Link-systems OmniLink II Press Automation Control Instrukcja Użytkownika Pobierz pdf (Strona 13)

August 30, 2002 Manual Version 1.0

2.4

Section 2.2 Mounting System Components

Section 2.2.1 Mounting the Operator Terminal Enclosure

The OmniLink II LCD Operator Terminal must be mounted in a position that is easily seen and accessed

by the operator. The liquid crystal display is designed for optimum viewing from the bottom of the

display. If the operator terminal is mounted in a vertical plane, it should be mounted slightly above the

operator's eye level for best visibility. If mounted in a sloped position, it should be mounted so that the

operator's line of sight is from the bottom of the LCD. The desirable orientations are shown in Figure

2.4.

Figure 2.4 LCD Mounting Orientations

The OmniLink II Press Automation Control operator terminal is usually furnished mounted on the front

of an enclosure, which also contains the R/D-Brake Monitor Module mounted in the back of the

enclosure and pre-wired to the operator terminal. Figure 2.5 gives the dimensions of the operator

terminal enclosure, including mounting dimensions.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 153 154

Brak uwag

Link-systems OmniLink II Press Automation Control Instrukcja Użytkownika Strona 13