Link-systems OmniLink 5000 Instrukcja Użytkownika Pobierz pdf (Strona 53)

5.6

Stroke

Mode

Sin

le Stroke

Drive

Speed

Stroke

Speed

SPM

200

Order

Counter

PC STATUS

Counter OFF

TOP STOP

CALIBRATE

CHANGE

NUMBER

Program/Run Switch

TOP

EXIT

MOTOR

SPEED

Speed Adjusted Top Stop

[ Calculated }

Speed Stop Ang

Ch A 100 340

Ch B 100 340

Stop Pos (Setup Mode) = 090

Manual Stroking Modes

Speed Low-High 0020 0100 RPM

Top Stop . . . . . . 0010 0050 BTDC

Continuous Stroking Modes

Speed Low-High 0020 0300 RPM

Top Stop . . . . . . 0010 0200 BTDC

Figure 5.4 Top Stop Configuration Menu Link High

Speed

The display shows the following information:

1. The program settings for modes that stop after each stroke (Inch, Timed Inch, Single Stroke, and

Automatic Single Stroke). These settings include a low speed (in Rpm) and associated top stop angle

(in Degrees Before Top Dead Center) along with a high speed and top stop angle. These two speeds

define the minimum and maximum operating speed for these stroking modes. The two top stop

angles should be set to stop the press at the top of the stroke at the speed limits. The press control

uses these settings to calculate coefficients that describe the stopping characteristics over the entire

speed range.

2. The program settings for modes that run several strokes before stopping (Continuous and Continuous

on Demand). The settings include a low speed (in Rpm) and associated top stop angle (in Degrees

Before Top Dead Center) along with a high speed and top stop angle. These two speeds define the

minimum and maximum operating speed for these stroking modes. The two top stop angles should

be set to stop the press at the top of the stroke at the speed limits. The press control uses these

settings to calculate coefficients that describe the stopping characteristics over the entire speed range.

3. The actual speed of the crankshaft and computed top stop position recorded by the press control each

time a stroke is made.

4. The programmed angle at which the press will begin to stop in the downstroke when operated in

Setup/Stop Time Test mode. See Section 5.1.3.

Section 5.1.2.1 Variable Speed Presses, Link High Speed

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 114 115

Komentarze do niniejszej Instrukcji

Brak uwag

Link-systems OmniLink 5000 Instrukcja Użytkownika Strona 53

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Link-systems OmniLink 5000